|Home Page | Gallery | PM Inbox | Forum Index|
Sodapopjones wrote:Depends on the brush, if its one that wasn't hand tied and is just a plug, good luck with that you're going to need a drill or a lot of patience and an ice pick to get all the epoxy out.
These are the steps I use before I bust the drill out,
Tape the entire handle with duct tape, making sure to go completely go around the collar and fold in the pieces of tape with my thumbnail.
A pair of scissors or sheers and trim the bristle down as far as possible
After that comes the drill
Squire wrote:Or band saw the handle in half lengthwise, chisel out what doesn't belong, epoxy the two halves back together . . . wait a minute, you don't have a band saw . . . never mind.
Users browsing this forum: No registered users and 0 guests