Face lathering and brush loading (soap)

[slackskin]

Gary - Do you still load the completely dry brush as outlined previously in this thread?

[brothers]

Yes, dry brush, loading on the soap that's been splashed with running tap water, then building the lather on the face. Here's a picture of what this brush looks like right now, a few hours after this morning's shave.

Semogue 2000 boar brush 12Feb2020.jpg (1009.12 KiB) Viewed 12771 times

[slackskin]

This morning I did as Gary recommended -- dry brush on soaked puck. Used a Fine Clsssic synthetic brush and Cyril Salter hard puck (similar to DRHarris). Worked well, probably would have been better if puck soaked longer. Will try again tomorrow

[brothers]

Various brushes respond differently depending on the amount of water that sits on the soap. When I switch to a different brush I occasionally get a bit too much or a bit too little water in the first few loadings before I get dialed in. In my case I'm guessing it's about 1 1/2 tablespoons to start with most of the time. Other guys may need more or less water to get the results that work best for them.

[JarmoP]

I use a well shaken badger brush and preload it with soap from bowl. Not too much soap in there like a whole puck and pretty much build some thick consistency lather there. Because only a relative small amount of soap.

Then I go to face and start making lather there. Dip maybe twice the brush hairs to sink in the process slighly. After the lather is finished on my brush I can go all needed passes without reloading. Maybe not with boar brush.

I don't rinse my face between the passes. Feeling it gets too much water remaining there that is upsetting the lather. I've always wondered this that some shavers rinse their face. I might still dip in the sink the brush slightly, thats all.

[brothers]

I use a well shaken badger brush and preload it with soap from bowl. Not too much soap in there like a whole puck and pretty much build some thick consistency lather there. Because only a relative small amount of soap.

Then I go to face and start making lather there. Dip maybe twice the brush hairs to sink in the process slighly. After the lather is finished on my brush I can go all needed passes without reloading. Maybe not with boar brush.

I don't rinse my face between the passes. Feeling it gets too much water remaining there that is upsetting the lather. I've always wondered this that some shavers rinse their face. I might still dip in the sink the brush slightly, thats all.

Six years later, and still one of the best recommendations ever.

" . . . committed to sustaining our site for as possible regardless of user activity."

[drmoss_ca]

I do rinse between passes, hoping that the hot water will penetrate and soften the cut ends of the stubble, making the next pass that bit closer.

[CMur12]

Between passes, I spray some water, with an atomizer, onto the skin to be shaved. Then I apply fresh lather.

This was suggested to me by Richard of Plano, Texas, soon after I started here. I forget what the problem was that prompted my request for advice, but I seem to get better glide when I do this.

- Murray

[Rufus]

I follow the Moss routine.